Ideas & plans Archive

Gallery of timing belt clamp ideas for linear motion

There are several ways to clamp open loop timing belt ends together. Here are some clamp ideas gathered into one post with images and some with comments. Most of them here are for GT2 belts, but some ideas work for others too. A quick overview to get ideas flowing and images for quick reference. It

Threaded rod joint using aluminium square tube

Just a quick and robust threaded rod joint idea I wanted to share in case someone is looking for inspiration. I needed simple cube-shaped construction and decided to make it out of threaded rods. It’s not accurate since holes are in offset, but I didn’t need actual cube so I am fine with it. I

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close