Metal Archive

DIY lightbox- My idea and building

I finally finished my DIY lightbox. I had the frame already assembled a few months ago. That frame was built using aluminum DIY profile corners and threaded bars. I have written about it in a separate post. Nothing too fancy, but does the job. I’ll share some photos how I built it. Parts used in my DIY

Threaded rod joint using aluminium square tube

Just a quick and robust threaded rod joint idea I wanted to share in case someone is looking for inspiration. I needed simple cube-shaped construction and decided to make it out of threaded rods. It’s not accurate since holes are in offset, but I didn’t need actual cube so I am fine with it. I

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close