Electronics Archive

Wiring and running TB6600 stepper driver with Arduino

A quick post about wiring TB6600 stepper driver which is based on TB6600HG chip. Here I use one without black plastic casing. It has model marking on the back that says “BL-TB6600-v1.2″. Stepper motor used in this demo is 23HS22-2804S (2.8A, NEMA23). Drive looks like this and it’s rated for 4.5A. Looking for more info and photos?

TB6600 4.5A photos without heatsink

A quick post about TB6600 stepper motor driver module. It should be 4.5A version. It has model marking on the back that says “BL-TB6600-v1.2”. This version has no plastic covering and has green PCB. Since originally everything is covered with large heatsink there is nothing much to see before removing it. Here I share some “closer look” photos

How to use H-bridge HG7881 (HG7881CP) module with external power supply and Arduino UNO

First-time use of H-bridge HG7881 (HG7881CP) module was pretty confusing for me. I didn’t find good (if any?) information about wiring this module up and running it with Arduino. But same time it seems to be quite popular. Here I share how I connected it to an external 12V power supply. You can use any other voltage

How to wire digital dual display volt- and ammeter

I bought this cheap “Chinese” volt- and ammeter gauge. This has shunt built-in so I don’t have to mess around with that. Unfortunately, I didn’t find any good resource how to wire/connect it. Actually, it’s not rocket science, but I had waited for it 2-3 weeks and didn’t want to blow it at first try.

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close